The location of the drawer was determined and then mounted based on the
future of the cabinet facing and door/working surface to be built. Note that the
horizontal shelf on the right that holds the inverter does not go all the way to
the back so access to the back is possible for wiring connections.
The kitchen unit is about the same height as most cooler's and will allow
for things to be stored away on top if additional space is needed.
Today I laid out the cabinet facing for the kitchen. All parts were drilled
using a pocket hole jig system and the parts were glued when assembled for extra
strength. (see photo above and below)
More TJ Camp Kitchen
4x4 Off-Road Homestead Firearms RC Flying